Instructions On How Best to Change a Tub Drain Overflow

The water flows out of the primary waste-water your bathtub via two channels drain as well as the over flow drain. The overflow is situated behind the cover which is installed immediately above your tub drain and under the the faucet. As time passes, the over flow drain can become clogged or corroded with hair and other particles carried using the water in to it. In the event the primary wastewater drain is working in excellent situation as well as correctly, it is possible to replace the over flow drain. It is a task that many homeowners can do themselves, with no pricey visit in the plumber.

The screws on the over flow drain protect using a screw-driver. Remove the cover and set it apart.

In order to begin to see the pipes on the other side of the tub, open the entry hole. This can be typically positioned on the wall copying to your bathtub’s pipes. Find the studs in the wall using a stud-finder when there isn’t any access hole.

Mark the studs’ area in the foot of the wall having a pencil, and after that cut a gap between these lines using a drywall saw. Try to keep the cut as clear as possible, so the panel can be replaced by you, and reduce to expose the stud.

Loosen the slip nut that retains the over flow pipe to the wastewater drain’s T-fitting by turning the nut counter-clockwise using locking pliers. In the event the nut doesn’t change, use a drop of lubricating oil that is of sunshine to it, and leave it to soak for a number of minutes. This ought to make it flip easier.

Lift the over-flow pipe from the wastewater’s T-fitting. The fitting should be lifted straight from by the over flow pipe.

Measure the duration of the over flow pipe to the bottom of the part from your part that is curved and slice the the over flow that is new to the sam e dimension utilizing a hack-saw.

Slide bushing and the slip nut which should be provided using the new over-flow pipe on the conclusion of the area that is straight.

Place the end-of the over flow pipe’s straight area to the T-fitting of the wastewater drain.

Turn the overflow pipe therefore the opening in the curved conclusion is facing toward the opening on the bathtub’s over flow.

Slide the bushing after which the slip nut on the most effective of the wastewater drain’s T-fitting, and after that tighten the slip nut with locking pliers. When the nut is tightened by you, it pushes the bushing contrary to the T-fitting to produce a water-tight joint.

Place the new over-flow drain protect contrary to the bathtub’s over flow opening and fall into line the screw-holes. Insert the screws in to the drain cover’s mounting holes, and fasten it in spot utilizing a screw-driver.

Fill your tub with water till it reaches over the over-flow drain protect, and analyze the pipes on the other side of the tub for leaks. Tighten the slip nut if required and after that drain the tub.

Replace the access panel to the wall. Set it straight back in location, and after that fasten it to the studs utilizing dry wall screws in the event you cut a piece out to create a panel.

See related